*Updated Pinhead Toothpick Dispenser
Added 2020-03-08 00:57:30 +0000 UTC*Fixed missing hole in bottom left cheek.
Printing Tips
- Generate support from PLATFORM ONLY, otherwise you will have supports inside the toothpick channels.
- Infill must be above 10% (I recommend 15-20%infill for the best internal support for the channels)
Enjoy :)
Comments
That depends, using basic maths, if the holes are measured for 2mmx63mm toothpicks (apparently the world standard says google) then if you rescale to 50%, your channels will be 1mmx31.5mm , so you would need to find toothpicks that size. To make the head smaller but for me to keep the same size holes meant the holes intersected and if there is not a separate channel for each pick, they just fall through
Geoffro / Hex3D
2020-03-15 03:37:39 +0000 UTCCan this be printed at 50% and still be functional?
Harjot Minhas
2020-03-15 02:23:41 +0000 UTCAwesome, thanks
James B
2020-03-12 19:14:15 +0000 UTC
